Egress Windows


    Egress Windows

    Egress Windows


    Egress Windows

    The International Residential Code - and virtually all building codes applied to all regions - require that all bedrooms have at least one egress windows, defined as a window large enough to allow occupants to escape in the event of a fire, or to allow a fully equipped firefighter to enter from the outside. The standard applies to windows installed in finished basements as well as bedroom windows.

    The IRC specifies the minimum width for an egress windows at 24 in.; the minimum height is 20 in., and the net clear opening requirement is 5.7 sq. ft. (5.0 sq. ft. for ground-floor windows. To comply with the code, an egress windows must be set with a maximum sill height of 44 in.

    Windows of all types, classified by materials, can be found on ebuild. Use the ebuild Specifier to narrow down your search and find single egress windows that fit the project requirements. You may choose single units, combination units, and bay and bow windows from listed manufacturers, including:

    You may also select values for key specifications to find suitable choices for egress windows:

    Window Format refers to the manufacturers' characterization of the unit with regard to design, function, and application, e.g., awning, basement, casement, etc.

    A selection in Venting Configuration indicates if the desired unit is to have venting capabilities or is to be stationary - i.e. non-operating.

    Nominal Height refers to the measurement across the longest side of the unit (from top to bottom), expressed in inches, and rounded to the nearest full inch.

    Nominal Width refers to the measurement across the shortest side of the unit (left to right), expressed in inches and rounded to the nearest full inch.

    Jamb Depth refers to the measurement of the width of the frame of the unit from the inside edge to the outside edge, expressed in inches.